TMC2208 Stepper Motor Driver Module

MC2208 is an ultra-quiet two-phase stepper motor drive chip, continuous drive current 1.4A, peak current 2A, voltage range 4.75V-36V, 256 subdivision. The flexible microPlyer interpolation unit provides up to 256 subdivisions, allowing perfect sinusoidal control even in systems with limited pulse frequencies; these are also designed because stealthChop2 ultra-quiet technology is widely used in 3D printing.
This product is known as 3D Printer TMC2208 Stepstick Stepper Motor Driver Module + Heat Sink, TMC2208 Stepper Motor Driver Module with Heat Sink for 3D Printer Part

Features:

Configuration: Step/DIR or UART
Micro-steps: 1/256
Current Loading: 1.2A continuous, 2A peak
Supply Voltage: 4.75 ~ 36V
Single Wire UART: for advanced configuration options

Features/Specs:

Model: TMC2208
Interface: Step/Dir
Configuration: CFG Pins or UART
Native Micro steps: Up to 1/256
MicroPlyer Micro steps: 1/256
Logic Voltage VIO: 3 ~ 5V
Motor Voltage VM: 5.5 ~ 36V
Motor Phase Current: 1.2A RMS, 2.0A Peak
Internal V-Regulator: Enabled
Size (LxWxH): 20 x 15 x 11 mm

Note !!!:

Make sure not to connect the motor when measuring voltage, otherwise driver will burn out.
When used on Ramps1.4 or MKS Gen, please remove the 3 jumpers under socket.
Pay attention to direction, don’t insert wrongly, or it will burnt out.
The motor direction is opposite to that of A4988 and DRV8825, please adjust the firmware or adjust the motor wiring if you want to replace A4988.